Industrial equipment HS code alignment

Cleaning the car engine: remove carbon and Industrial equipment HS code alignmentdirt and restore power. After a long time of operation, modern car engines will produce a large amount of carbon and dirt, which seriously affects the performance of the engine, causing the vehicle power to decrease and discharge The release volume will increase, and even engine failure will occur. In order to ensure the smooth and efficient operation of the car, it is very necessary to clean the car engine. I. The main reason for the formation of carbon dirt in automobile engines. The main cause of carbon accumulation in automobile engines is the incomplete combustion of fuel. The residual oil slag will precipitate inside the automobile engine and gradually accumulate to form carbon. At the same time,The impurities generated by the car during driving, the frequent start and stop of the vehicle, the sudden braking, etc. will also aggravate the accumulation of carbon, thus affecting the normal operation of the engine. II. The importance of cleaning automobile engines. Cleaning automobile engines is of great significance. It can not only avoid a variety of problems caused by excessive carbon accumulation, but also improve the efficiency of automobile engines, improve the safety and comfort of driving, and also achieve a variety of effects such as reducing fuel consumption and environmental pollution. III. Cleaning method 1. Chemical cleaning method Chemical cleaning method is a common cleaning method, which mainly sprays detergent through the intake of the engine for cleaning. The cleaning agent can penetrate deep into the carbon inside the engine and burn the carbon into gas, thus achieving the purpose of cleaning the engine. This method is simple and convenient, and the effect is relatively obvious.However, due to the large differences in the quality and brand of chemical detergents, improper use may have adverse effects on the engine, so a reliable service provider must be selected. Two. Mechanical cleaning method Mechanical cleaning method is a relatively old cleaning method. The most common is to disassemble the engine for cleaning. Disassembly and cleaning of the engine can remove carbon more thoroughly, but it requires more professional technology and equipment, and will cause a certain waste of time and financial resources. Therefore, most car owners will not choose the mechanical cleaning method. In addition, there is also a method of using ultrasonic cleaning equipment to remove carbon stains through ultrasonic vibration. However, the cost of this kind of equipment is relatively high, requiring professional operation technology and experience, which is not very convenient for ordinary car owners. IV. Precautions Before cleaning the engine, you need to pay attention to the following points: 1.Cleaning frequency. The frequency of engine cleaning will affect the performance of the engine itself. In general, we recommend driving 10,000 kilometers every other year. Two. Cleaning time. It is best to clean it after normal operation, so that the engine can reach a good condition. 3. The quality of the cleaning agent. It is necessary to use regular channels to purchase detergents that have obtained test certificates, and avoid using inferior detergents, which will cause adverse effects on the engine. Four. Professional technology and equipment. It is recommended to choose a professional automobile repair center for engine cleaning to avoid engine damage caused by improper operation. V. The effect after cleaning. After cleaning, the efficiency of the engine has been improved, the power is stronger, the fuel consumption is reduced, and the emissions are reduced. At the same time, it can also extend the service life of the engine, and the vehicle is safer, more stable and more comfortable.VI. Summarize that there are many ways to clean automobile engines, such as mechanical cleaning, chemical cleaning and ultrasonic cleaning. Each method has its own characteristics and scope of application, and it is necessary to choose the appropriate cleaning method according to the actual situation of the vehicle. Cleaning the engine can greatly improve its efficiency, extend its service life, and also protect the environment and reduce pollution, which is a very beneficial job.

Contact Us
Phone：020-83484638