APAC trade flows by HS code

Full analysis of engine timing adjustment The APAC trade flows by HS codeengine is the core component of the car. As one of the most important systems in the engine, the timing system controls the smooth work and efficiency of the engine. Therefore, it is very important for car owners to master the timing system adjustment technology. Introduction What is engine timing? It refers to the working time between the engine valve and the piston to ensure that the fuel can burn smoothly in the engine cylinder and drive the vehicle. The adjustment of the timing system is to ensure that this matching time can work correctly and efficiently. Time adjustment process 1. Check the timing system. Before timing adjustment, all parts of the timing system must be checked first.This includes crankshaft sensors, camshaft sensors, crankshaft gears, camshaft gears, and other related components. These parts must be properly installed on the engine without any damage or wear. Two. To find the timing marker, you need to find the timing marker of the engine. Generally speaking, the timing mark is located behind the crankshaft pulley on the engine or on the camshaft pulley. These marks are usually marked with "TDC" (upper stop point), which is the starting point of our timing adjustment. 3. Move the intake piston. In order to better adjust the timing, it is necessary to move the intake piston to the position of the timing mark. This can be done by unscrewing the bolts and nuts on the cylinder head, and then pushing the valve open to loosen the compression. Four. Adjust the crankwheel. Now we can start to adjust the crankshaft pulley or directly adjust the crankshaft wheel.Rotate the crankshaft gear until the timing mark of an engine is fully aligned with the laser lamp. At this time, you can fully align the camshaft gear by rotating the camshaft pulley. Make sure that the belt between the camshaft gear and the crankshaft gear generates the correct tension. 5. Check the oil pump. If you find that the timing mark is not in its position when the intake valve is closed, it may be that the oil pump wheel is not fully aligned with the camshaft gear. In this case, you need to increase or decrease the number of teeth of the oil pump wheel in order to start the engine at the correct timing mark position. 6. Adjust the intake valve. After you have completed the above steps, you need to check the timing adjustment of the intake valve. If you find that it needs to be adjusted, you can adjust the timing of the intake valve system by loosening the pulley and the valve. Conclusion The importance of mastering the engine timing adjustment technology is self-evident.In the timing system, better matching time can bring better engine performance and longer service life. When making on-the-time adjustment, make sure that each step is very careful and attentive to ensure that your adjustment results are correct and fixed. Finally, after completing all adjustments and checks, please remember to test to ensure that the engine timing adjustment is correct and runs smoothly.

Contact Us
Phone：020-83484638